The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old February 3, 2000, 06:01 PM   #1
Junior Member
Join Date: September 19, 1999
Posts: 5
A friend just bought a remington rifle with a synthetic (plastic) stock is there a way to mount sling swivels safely to these stocks or is there a special type of sling that you use with these?

herman is offline  
Old February 3, 2000, 07:45 PM   #2
Join Date: January 10, 2000
Location: South Charleston, W.Va. USA
Posts: 42
I would have thought the stock from Rem. would already have the swivel studs attached?? If not, you do need to be somewhat careful in doing so for you will find that the butt sections is hollow and only filled with some sort of structural foam, etc. The wall thickness is fairly thin and can sling stud can pull out. Once you locate and drill the hole for the stud, suggest you inject a fair amount of bedding compound such a Accr Glass, Devcon, Marine Tex, etc. and also on the stud itself and let that "set up" for a least a day or so. The compound will impart some additional strength to the area where the stud goes, and keep it there. Position the stock where the compound while still semi-fluid will settle down around the stud screw portion inside the stock. The forend can be done the same way, but I prefer to drill clear through the barrel channel and inlet a section for a nut and then use the compound to secure. Be advised;however, that once you do this, removal of the studs is probably not an option in the future!! It is there to stay. Should have mentioned that you will have to remove after drying any compound which is above the bottom of the barrel channel or will impact on barrel, once you torque the action down. Not a big job. Good Luck
MontaniSemperLiberi is offline  
Old February 3, 2000, 11:51 PM   #3
George Stringer
Staff Alumnus
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Herman, MSL gave you some good advice. I'm going to go a little further and advise you to let your local smith do it. Most guys won't charge more than $15 or $20 to install swivels. George
George Stringer is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 08:39 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2016 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05151 seconds with 7 queries