The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old December 21, 2005, 06:18 PM   #1
Senior Member
Join Date: October 15, 2005
Location: orange county, ca
Posts: 610
front serrations

If wanted to customize my slide with front serrations, where could I get it done?
choochboost is offline  
Old December 21, 2005, 11:02 PM   #2
Harry Bonar
Senior Member
Join Date: December 5, 2004
Location: In the Vincent, Ohio general area.
Posts: 1,804

Dear Shooter:
Find someone with a mill. If it is a standard size, mount it in a good vise with the adapter, set the head at 30 degrees, (head to the left , mtr. etc cutter to right) spacing is .070 per, measure back 1.400 to cut your first serration (3/8" cutter in R-8) come down .025 deep and start cutting from rear to front - cut 12 serrations, reverse slide and do same. It's done!

The "adapter" is what you mount the slide on horizontally which takes the "taper" out of the fix.
Harry B.
Harry Bonar is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 05:07 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04082 seconds with 7 queries