The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old December 21, 1999, 02:53 AM   #1
Posts: n/a
I have a kel tec P11 & 32 that I would like to nickel plate(open to suggestions) for corrosion resistance. Are there any parts on the slide that should not be plated besides the sites and the firing pin?


Old December 21, 1999, 08:20 AM   #2
George Stringer
Staff Alumnus
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Olazul, the smith who does the plating will know which parts can and which can't be plated. The alloy frame on a Kel-tec can't be nickeled. I have an associate who does very good with either nickel or chrome. If you do it in a brushed or satin the frame can be anodized to match. George
George Stringer is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 11:56 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05887 seconds with 9 queries