The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old July 5, 1999, 06:24 PM   #1
Junior Member
Join Date: June 29, 1999
Posts: 5
would it be possible to have an internal choke tube installed on a winchester model 97 12ga? Can most gun smiths do that job? Would it matter if the barrel had been shortened? Thanks in advance.
JoeM is offline  
Old July 5, 1999, 07:36 PM   #2
James K
Join Date: March 17, 1999
Posts: 24,189
If the '97 is in any kind of good condition, it has more value as a collector's item than as a hunting gun. Something to consider.

I don't know about most gunsmiths, but there are many who can install those tubes and I don't know any reason why they can't be installed on a '97.


James K is offline  
Old July 5, 1999, 10:04 PM   #3
George Stringer
Staff Alumnus
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Joe, there is no reason that tubes couln't be installed in your 97. Actually I prefer putting them in older guns. There is usually more meat in the barrel walls. And as far as the barrel being shortened, that normally translates into even greater wall thickness so it doesn't hurt a thing. Any competent smith with the proper tooling should be able to do this for you. The tooling is expensive and a lot of smiths would sooner farm it out than buy the equipment. If you can't find anyone near you, e-mail me. I'd be happy to do it for you. George
George Stringer is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 07:20 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.06549 seconds with 9 queries