The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old April 3, 1999, 12:35 AM   #1
Senior Member
Join Date: March 28, 1999
Location: WA
Posts: 515
Can anyone tell me the easiest way to replace the trigger return spring in a Taurus model 85? I got the mainspring in Ok, but I can't figure out how to get the trigger return spring out.
glockorama is offline  
Old April 3, 1999, 08:56 AM   #2
George Stringer
Staff Alumnus
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Glockorama, when you pull the trigger to the rear the spring guide will come back through its stud. There is a hole in the guide. Insert a small pin, bent paper clip, etc., through the hole and it will hold the spring under tension while you remove the trigger. Once the trigger is out of the way, control the spring and remove the pin. Installation is the reverse. George
George Stringer is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 08:12 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.06220 seconds with 7 queries