The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old March 30, 1999, 09:30 AM   #1
Join Date: October 28, 1998
Location: Aberdeen,wa,usa
Posts: 79
I am thinking of putting a 20"/RPK barrel on one of my AKs. Is this a difficult process? Is it possible?

Phantom Menace May 21st! Star Wars is back.

shane is offline  
Old March 31, 1999, 07:29 AM   #2
George Stringer
Staff Alumnus
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Shane, while I've never rebarreled an AK it's been my experience that as long as a barrel or blank can be machined to fit a receiver then it can be done. I'm not sure what you might run into with this, but my recommendation is that any rebarreling be done by a smith. Any good smith could do it, but I'd find somebody who specializes in AKs. George
George Stringer is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 05:02 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2016 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04702 seconds with 7 queries