The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Gear and Accessories

Thread Tools Search this Thread
Old January 12, 2000, 12:42 AM   #1
Senior Member
Join Date: August 11, 1999
Location: Houston, TX
Posts: 238
I just picked a used USGI Adventure Line 20rd mag at a local gunshow. This mag has an alloy follower.
Using American Eagle 55gr FMJ loads, the last round will jam against the bolt and locking lug on the lower left side.
It appears that the follower can move around not positioning the last round to properly feed. Is this a mag spring issue or do I need a new follower that has a tighter fit inside the mag body?
Spirex288 is offline  
Old January 12, 2000, 03:34 PM   #2
Posts: n/a
Adventure LIne are normally ok... but sounds like the spring is worn out..... try streaching it just a bit.... .... we almost never put more than 17-18 rds in a 20 rounder just for that reason

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 10:27 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04162 seconds with 7 queries