The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Gear and Accessories

Thread Tools Search this Thread
Old November 2, 1999, 01:56 PM   #1
Senior Member
Join Date: July 4, 1999
Posts: 230
Can someone recommend a decent case, preferably hardshell, that can hold both an AR-15 and a shotgun? Something not too pricey. Thanks!

[This message has been edited by shamster (edited November 02, 1999).]
shamster is offline  
Old November 2, 1999, 02:28 PM   #2
Join Date: October 6, 1998
Location: My wife's house...
Posts: 2,659
Moving your request to the Gear & Accessories Forum, so you can get a faster answer.
. is offline  
Old November 2, 1999, 06:53 PM   #3
Senior Member
Join Date: August 29, 1999
Posts: 928
I don't know what your price range is, but Dillon Precision has aluminum hard cases from Ziegel Engineering that are reasonable. They are over $100.00 though. Doskocil and Gun Guard make inexpensive plastic cases that are well under $100.00.
slickpuppy is offline  
Old November 2, 1999, 08:05 PM   #4
Senior Member
Join Date: November 18, 1998
Location: NE OH, USA
Posts: 3,198
I have a 'Field Locker' which, as I recall, is a Doskocil. A very durable plastic 2-gun case. Padded, eggcrate-type foam. Three very strong latches per side. It is capable of holding my scoped bolt-actions with additional room, even ammo. It should be able to handle the 15 with its pistol grip (minus the mag).

Short comings :

Long - Have to drop the rear seats of my car to fit the case in. Somewhat unwieldy, particularly with two guns in it (weight).

Feet - The four molded-in feet have sharp corners that tend to snag on carpeting, upholstery, etc.

Interior Clearance - With a sunshade attached to a scope, it comes very close to the plastic edges of the inside. A good bump could cause the gun to shift (despite a tight fit between the foam pads) and damage the scope.

Flex - The plastic does flex a bit if you have alot of stuff in the case. You might have to close the lid a couple of times or press in a couple of places so the lid and body edges line up.

Water Proof - Not.

Overall, however, I think its a good buy at under $50. (I think I paid $35-$40. It was a long time ago.) It can take a beating and you won't mind the dings and scratches.

If you want something a little more durable and water tight you might want to try a Pelican or Browning (which I think is made by Pelican). I've been meaning to get a couple.

- Ron V.

hksigwalther is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 11:26 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04828 seconds with 9 queries