The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > NFA Guns and Gear

Thread Tools Search this Thread
Old May 13, 2000, 01:29 PM   #1
kentucky joe
Junior Member
Join Date: May 12, 2000
Location: princeton,ky,usa
Posts: 5
No,im not planning on performing this illegal just trying to get enough information to end an arguement with one of those know it all poeple i work with.He says all thats required to convert a new bushmaster lower to a functional m16 is all the m16 fire control parts and bolt carrier.and all the machining thats required is to drill the autosear pin hole above the selector switch,but from my understanding you would also have to mill out some of the reciever to allow room for the autosear since the xm15 recievers are not fully milled like the m16 recievers are.i know it still wouldnt be that hard just remove a little bit of the reciever on each side,but whos right about this me or him.thanks alot:kentucky joe
kentucky joe is offline  
Old May 13, 2000, 02:34 PM   #2
Join Date: December 14, 1999
Posts: 99
You are correct. You'd need a bolt carrier, hammer, auto-sear, selector and disconnector. Then, mill and drill, but since you live in Kentucky, why risk a long stay at Club Fed when you could pruchase one legally?

[This message has been edited by KAC556 (edited May 13, 2000).]
KAC556 is offline  
Old May 13, 2000, 10:56 PM   #3
4V50 Gary
Join Date: November 2, 1998
Location: Colorado
Posts: 19,342
On the Bushmaster, I think only a bit of metal would need to be removed from one side of the receiver for a regular auto-sear or burst mechanism to work. Of course, other parts named earlier are required.
4V50 Gary is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 06:40 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04395 seconds with 7 queries