The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old November 8, 2004, 01:16 PM   #1
Senior Member
Join Date: July 22, 2004
Location: Dallas, TX (area)
Posts: 128
Laser Cast .40 load

I'm looking for suggestions on good starting loads for a general target load with the following components:

Laser Cast 180 grain FN .40 S&W Lead bullet
Winchester WSP primers
Hodgdon Titegroup powder

I used 4.2 grains of Titegroup under the Speer FN 180 grain bullets I first used, but I decided to go with Laser Cast this time to make the shooting more economical (500 @ 26 bucks VS. 100 @ 15 bucks).

Can I just use the same load with the lead bullet as I did jacketed? The 4.2 grains was on the low end of the recommended load for the previous setup, so I was thinking it would be a good place to start.

Thanks in advance.
beardking is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 08:15 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.03988 seconds with 7 queries