The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old March 18, 2002, 01:37 PM   #1
Join Date: February 12, 2001
Location: Minneapolis, MN
Posts: 81
10/22 bolt

How do you remove the bolt from a 10/22? I accidently used a dah too much locktite on my scope base and I need to remove my bolt to clean everything out.
tator is offline  
Old March 18, 2002, 02:30 PM   #2
Senior Member
Join Date: November 5, 2000
Location: Wyoming
Posts: 1,761
Separate the action from the stock. Push out the two pins holding the trigger group from the receiver as well as the bolt stop pin located at the rear of the reciever and remove the trigger group. Invert the receiver, pull the charging handle back as far as it will go, and while holding the charging handle in the rear position, pull up on the front of the bolt and it will come out easily once it clears the bolt guide rails.
DAVID NANCARROW is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 08:51 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04805 seconds with 7 queries