The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old April 1, 1999, 04:52 PM   #1
Nestor Rivera
Senior Member
 
Join Date: October 20, 1998
Location: San Antonio, Texas, USA
Posts: 446
I am looking to a bullet with a .329 diameter
for reloading the 8x56R I know that .323 can be used but I would like to get a little closer. any sugestions
Nestor Rivera is offline  
Old April 1, 1999, 05:14 PM   #2
bfoster
Senior Member
 
Join Date: October 13, 1998
Location: N. of Fords Switch, OK, USA
Posts: 297
Try www.huntingtons.com/dkt.html
These are not cheap, but the diameter is right. Good luck & good shooting.

------------------
bfoster is offline  
Old April 18, 1999, 03:10 PM   #3
dundee
Senior Member
 
Join Date: December 6, 1998
Location: mytown,mi,usa
Posts: 162
If you can not find a good supply of this odd size bullet you should try using the smaller .323 size and see what results you get. If the results are not to your liking, try contacting one of the swaging die manufactured about getting a custom die to 'bump up' the .323 bullets to the diameter needed by your barrel.
dundee is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:19 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.05336 seconds with 10 queries