|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
April 19, 2009, 08:07 PM | #1 |
Senior Member
Join Date: March 24, 2009
Location: RGV, Tx
Posts: 787
|
yet another question about my jp sauer & son western marshal 357 magnum s/a revolver
I have found all but one part. I need a base pin for it and I was wondering if that base pin is the same size as another brand ( i.e. ruger ect.) and if they are interchangeable.
__________________
And death climbs the steps one by one, To give you the rose that's been burnt by her son, Point me to the sky above I can't get there on my own, Walk me through the graveyard Dig up her bones |
April 20, 2009, 08:12 AM | #2 |
Senior Member
Join Date: September 19, 2008
Posts: 4,678
|
If you have no other cylinder pin for a trial fit, have you measured the hole diameter & depth ?
A drill bit shank might get you close enough - or carry the cylinder to gunshows and ask the parts guys for a match. |
April 20, 2009, 02:27 PM | #3 |
Member In Memoriam
Join Date: March 17, 1999
Posts: 24,383
|
A base pin is usually an easy part to make if you can't find one.
Jim |
|
|