|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
January 21, 2014, 08:15 PM | #1 |
Senior Member
Join Date: March 21, 2012
Location: Connecticut
Posts: 2,378
|
Dehumidifiers effectiveness
How effective are safe dehumidifiers? Looking at the flexible one browning makes.
Thanks |
January 22, 2014, 01:40 PM | #2 |
Senior Member
Join Date: November 4, 2012
Location: Georgia
Posts: 908
|
Anything is better than them being in ambient conditions.
I would go with something like this. Highly rated, has a gauge to tell you when it is full of water and when it's full of water you plug it into a wall socket and overnight it dries it out. Many of the reviewers have put them into gun safes. http://www.amazon.com/Stack-On-SPAD-...productDetails Also consider getting a humidity gauge for the inside of the gun safe, or if you want to spring for it one inside and one outside if you want to know how much drier it is inside vs ambient humidity in your house. |
January 22, 2014, 02:38 PM | #3 |
Staff
Join Date: March 4, 2005
Location: Ohio
Posts: 21,061
|
The heater types reduce relative humidity by warming the air, but mainly, by making the guns a little warmer than ambient, they prevent condensation when you remove them from the cabinet.
The desiccant types work until they are saturated. Generally, the amount of humidity in a closed space rises as their water content increases, so you want to "recharge" them (actually not charging, but driving water back out in a low oven). Or you can just get some of the smectite clay (bentonite or montmorillonite) type of granular oil absorbent or unscented and untreated kitty litter, spread it out on a cookie sheet and bake it for an hour at 450° or a little higher. While cooling, but still warm, drop it into an unwaxed plain brown paper bag, roll it up and put some rubber bands around it to keep it closed, and set it in the gun safe. This is what mil-spec desiccant is often made from. Moisture will permeate the paper bag just fine. This stuff has no color indicator, but a cheap humidity meter or dropping a small commercial silica gel pack with color indicator into the box with it will tell you when the humidity is no longer being controlled. Below about 40% R.H. rusting is essentially impossible, but below 60% it has a much harder time starting. Besides, below 50% you can get into issues with oiled wood getting too dry. A compressor type dehumidifier is best if you have room for it. It draws water out of the air by condensation on a cooled coil, then puts it intp a collection container or runs it down a drain. Much more trouble than the other stuff as it needs not only AC power, but a drain tube or regular emptying. This is the fastest type for drying wet air.
__________________
Gunsite Orange Hat Family Member CMP Certified GSM Master Instructor NRA Certified Rifle Instructor NRA Benefactor Member and Golden Eagle Last edited by Unclenick; January 22, 2014 at 09:53 PM. |
January 22, 2014, 03:05 PM | #4 |
Senior Member
Join Date: January 24, 2013
Location: NC
Posts: 545
|
Safe= large thermal mass. The reason it feels cold is the same reason it tends to make condensate out of normal house air. It's like the outside of your tea glass. The wet on the outside of your sweet tea came from the room.
I like the plug in and dry out type. There is no need to look for humidity in your safe, it's in the air already as a gas and will condense on metal surfaces in your safe. Making safes out of less conductive material would be the only solution I can think of. |
January 22, 2014, 07:10 PM | #5 |
Senior Member
Join Date: March 21, 2012
Location: Connecticut
Posts: 2,378
|
Thanks for the replies. I have a compressor dehumidifier but wasn't sure how well it would work with it being outside the safe. Plus it doesn't have its own drain so needs to be emptied frequently.
|
January 22, 2014, 10:09 PM | #6 | |
Staff
Join Date: March 4, 2005
Location: Ohio
Posts: 21,061
|
Quote:
Itar, If you put the dehumidifier actually into the safe, it won't take long to get the bulk of the water out of the air and that won't be enough to fill the reservoir. But its humidistat will keep cycling it back on every time enough of that water re-evaporates from the reservoir or enough addition moisture dissolves in from the outside through anyplace in the safe that's not hermetically sealed. Similarly, if the air outside the safe is kept dehumidified, moisture in the safe will gradually work its way out. You may find it less expensive (and less room consuming in the safe) to run one of the heaters inside it, but dehumidify the surrounding air as much as it is in your budget to do.
__________________
Gunsite Orange Hat Family Member CMP Certified GSM Master Instructor NRA Certified Rifle Instructor NRA Benefactor Member and Golden Eagle |
|
January 23, 2014, 05:44 AM | #7 |
Senior Member
Join Date: March 21, 2012
Location: Connecticut
Posts: 2,378
|
I'm looking at the flexible dehumidifier as it will take up less room the a golden rod. Should be equally effective as well as a room dehumidifier
|
January 27, 2014, 11:41 AM | #8 | |
Senior Member
Join Date: January 24, 2013
Location: NC
Posts: 545
|
Quote:
1) sunlight from a window in the daytime. 2) Safe sitting on a cold floor. 3) External heat sources (space heater and room vents) Internal heat in the safe is a good idea. |
|
February 9, 2014, 06:48 PM | #9 |
Junior Member
Join Date: December 22, 2013
Posts: 9
|
Bentonite clay
The crystal kitty litter is Silica Gel, same as the desiccant packs. The clay based ones are bentonite....and bentonite is a great desiccant, used in "desi-paks", among others. You can't go wrong with cat litter...no matter what anyone says.
|
February 9, 2014, 07:55 PM | #10 |
Staff
Join Date: March 4, 2005
Location: Ohio
Posts: 21,061
|
Just watch out for scented or deodorizing cat litter. I have no idea what the additives do if you heat them to drive water out.
__________________
Gunsite Orange Hat Family Member CMP Certified GSM Master Instructor NRA Certified Rifle Instructor NRA Benefactor Member and Golden Eagle |
February 9, 2014, 08:17 PM | #11 |
Junior Member
Join Date: December 22, 2013
Posts: 9
|
Good point...unscented would be the way to go if you plan on recharging it.
|
|
|