The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old December 14, 2011, 05:26 PM   #1
boostedtt91
Senior Member
 
Join Date: January 28, 2011
Location: Danville, Pa
Posts: 520
RCBS .223 Dies Bad Batches

I would just like to give everyone a heads up if you get any new RCBS reloading dies in .223. There was a bad batch of them they were sent out where all the depriming/sizing die center rod is bent and the decapping pins are bent. I bought a set and my buddy bought a set a week later from a different place and both our sets were bent out of the box. We called RCBS and they told us there was a bad batch so just a heads up. They will send you replacement parts for free with a bunch of decapping pins.

So check you dies before using them
boostedtt91 is offline  
Old December 14, 2011, 06:24 PM   #2
solitude127
Member
 
Join Date: December 5, 2011
Location: Southern California
Posts: 74
I'm on the west coast and bought mine from Midway and thankfully I got a good set.
solitude127 is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:37 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.03910 seconds with 10 queries