|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
June 10, 2008, 02:02 PM | #1 |
Junior Member
Join Date: June 9, 2008
Posts: 2
|
Model 190 drawings/parts list needed
After digging out my old 1972 model Winchester 190 and running several rounds through it I discovered It has so much gunk inside it wants to jam. My buddy said to pull the pin and clean it. In doing so I seem to have broken either the end of the ejector or firing pin. It still fires but about every other round the brass gets hung up. Can anyone send me some drawings and take down procedures so I can get it fixed and prevent this again? I'm Confused!
|
June 10, 2008, 03:18 PM | #2 |
Senior Member
Join Date: June 20, 2007
Location: Rainbow City, Alabama
Posts: 7,167
|
If you do a search on here, there is a very long thread about this rifle. Good luck.
|
|
|