March 18, 2013, 08:34 PM | #1 |
Senior Member
Join Date: November 18, 2010
Posts: 595
|
Scope Question
Ok, so there I was...
Took my SPR clone AR15 to the range Sunday to get it zeroed. I was shooting at the 25 yard line, the plan being go for 1.5 inches high at 25 then fine-tune it at the 100 yard line. While adjusting, I ran out of elevation. I went as far down as I could but point of impact was still about a foot or so above point of aim. I'm sure I'm not the first person this has happened to. The scope is a Leupold Mk IV and the mount is a Burris PEPR mount. I think the answer is mount-related but I'm not an expert in these things, so I figured I'd ask around. Any help would be greatly appreciated. Thanks.
__________________
Good equipment will never be a substitute for good training. |
March 18, 2013, 08:51 PM | #2 |
Senior Member
Join Date: February 15, 2009
Posts: 8,927
|
It's a problem with the mount and/or rings. Their elevation plane is angled too much below the bore axis; the rifle shoots too high. Make sure they're the correct ones for your rifle.
|
March 18, 2013, 09:00 PM | #3 |
Senior Member
Join Date: November 18, 2010
Posts: 595
|
http://www.burrisoptics.com/arpepr.html
That's the link to the Burris website for the mount. It's designed for AR's, and I've had it zeroed before it was painted, so I'm not sure where to start looking at this problem.
__________________
Good equipment will never be a substitute for good training. |
March 19, 2013, 05:35 AM | #4 |
Senior Member
Join Date: February 15, 2009
Posts: 8,927
|
How does one "zero" that mount?
|
March 19, 2013, 07:52 AM | #5 |
Moderator Emeritus
Join Date: June 25, 2008
Location: Austin, CO
Posts: 19,578
|
Scope Question
1 1/2" high at 25?
Do you WANT to be a foot high at 100? |
March 19, 2013, 08:05 AM | #6 |
Senior Member
Join Date: November 18, 2010
Posts: 595
|
That should have said 1.5 inches LOW at 25, not high. Good eye, sorry about that.
Also, I meant that the rifle was zeroed before taking the scope and mount off to be painted.
__________________
Good equipment will never be a substitute for good training. |
|
|