|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
December 20, 2015, 03:04 PM | #1 |
Senior Member
Join Date: April 22, 2015
Location: NE Tennessee, a "Free State"
Posts: 478
|
Inline Fabrication and Lee Loadmaster
I have a Dillon 550B on the Dillon riser. I really enjoy the height of the Dillon. I also have started using my Lee Load Master, again. I do NOT like the low mounting. It is attached to the edge of the workbench. I have toyed with the idea of another Dillon riser and putting the Load Master on it but the Inline Fabrication unit has caught my attention. There are two sizes, the 9 3/4 inch and a 6 inch model. I lean more toward the 6 inch model as the Lee seems to be taller than the Dillon. Any "Forum: input on which might be best?
|
December 20, 2015, 03:11 PM | #2 |
Member
Join Date: June 29, 2014
Posts: 88
|
I have the 9 3/4 one for my Loadmaster. Don't know if the 6" one has enough clearance.
|
|
|