Rossi 92 problem

smuckie · September 21, 2013, 10:35 PM

can you just remove the breach bolt in a Rossi 92, got part of a separated case stuck in breach and am trying to remove it, thanks

DnPRK · September 21, 2013, 11:35 PM

Some dis-assembly is needed to remove the breach bolt. Not hard to do, but pay attention.

The lever and locking bolts have to come out, which means the ejector gets released.

If you use a slave pin and dummy cartridge to hold the ejector in place, it is easier to re-assemble.

While the breach bolt is out, I recommend replacing the ejector spring. Doing so smoothed out cycling on my Rossi 92.

smuckie · September 22, 2013, 08:03 PM

I knew I could count on you experts

September 21, 2013, 10:35 PM	#1
smuckie Member Join Date: October 12, 2012 Location: Ohio Posts: 66	Rossi 92 problem can you just remove the breach bolt in a Rossi 92, got part of a separated case stuck in breach and am trying to remove it, thanks __________________ Eyes are getting old? Get a bigger gun or larger mags

September 22, 2013, 08:03 PM	#3
smuckie Member Join Date: October 12, 2012 Location: Ohio Posts: 66	Thanks I knew I could count on you experts __________________ Eyes are getting old? Get a bigger gun or larger mags

September 21, 2013, 11:35 PM	#2
DnPRK Senior Member Join Date: August 24, 2001 Location: LC, Ca Posts: 1,917	Some dis-assembly is needed to remove the breach bolt. Not hard to do, but pay attention. The lever and locking bolts have to come out, which means the ejector gets released. If you use a slave pin and dummy cartridge to hold the ejector in place, it is easier to re-assemble. While the breach bolt is out, I recommend replacing the ejector spring. Doing so smoothed out cycling on my Rossi 92.