The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old December 14, 2011, 05:04 PM   #1
p5200
Senior Member
 
Join Date: April 1, 2008
Posts: 241
Forster Coax press model B2 OR B3?

Can anyone tell me the differences in yoke measurements of the B2 and newer B3 model presses. I'm trying to figure out which model I have Thanks!
p5200 is offline  
Old December 14, 2011, 05:54 PM   #2
rg1
Senior Member
 
Join Date: November 6, 2001
Posts: 1,100
Mine is the older version before they lengthened the yoke. I just used a tape measure and eye-balled the dimensions. With the handle raised to point straight up I get approximately 4 7/8" from the inside bottom of the yoke to the center of the main pivot pin. With the press ram raised to the top and the handle all the way forward and down I get 6 1/2" from the top linkage pin center to the inside of the yoke. Rough measurements but should be close enough to tell which model you have.
rg1 is offline  
Old December 14, 2011, 06:07 PM   #3
p5200
Senior Member
 
Join Date: April 1, 2008
Posts: 241
Thanks for taking the time to measure yours I really appreciate it!
p5200 is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:52 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2020 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.04283 seconds with 10 queries