|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
February 3, 2014, 01:08 AM | #1 |
Junior Member
Join Date: January 29, 2014
Posts: 9
|
Are all Mauser followers the same?
I need to replace my follower and spring. The spring is old and I think it is too weak to feed shells. The follower has the high back that stops closing when empty. It is stamped, not solid, so I can't file it down.
Are all followers and springs interchangeable? They are easy to find on the internet but I don't know if they vary in size. Thanks. |
February 3, 2014, 04:37 AM | #2 |
Senior Member
Join Date: October 19, 2005
Location: Tx Panhandle Territory
Posts: 4,159
|
A lot of them are the 'same' enough to work, however, there have been a lot of different Mausers and calibers made over the past 100+ years. If you could identify what type of receiver you have precisely, you could look further at Numrich Gun Parts. Just scanning through their lists of Mausers they list parts for- you can see how 'one size just probably won't fit all'.
Edit: I just noted where you said your follower is stamped. Could it be that you have a Yugo 48?
__________________
Rednecks... Keeping the woods critter-free since March 2, 1836. (TX Independence Day) I suspect a thing or two... because I've seen a thing or two. |
February 3, 2014, 08:32 AM | #3 |
Member
Join Date: January 15, 2014
Location: The Gunshine State
Posts: 70
|
U know that some mausers have a follower that prevents the bolt from being closed on an empty chamber without depressing it first. I'm sure there are other differences, but that's an obvious one,
|
February 3, 2014, 11:11 AM | #4 | |
Senior Member
Join Date: October 18, 2006
Posts: 7,097
|
Quote:
Jimro
__________________
Machine guns are awesome until you have to carry one. |
|
February 3, 2014, 11:43 PM | #5 | |
Junior Member
Join Date: January 29, 2014
Posts: 9
|
Quote:
It is chambered for 270 Win, which I like, but doesn't feed worth a damn. I have cleaned it up and polished the edges. I don't want to remove any material since it is hard to put back. I will get a better spring and hope that solves the feed problem but I can't cut my follower down since it is stamped, not solid. They are easy to find, I just don't know if they are all about the same. |
|
February 3, 2014, 11:50 PM | #6 |
Member In Memoriam
Join Date: March 17, 1999
Posts: 24,383
|
Is there any crest or marking on the top of the receiver ring? The gun sounds like a standard 98 Mauser and if so about any 98 Mauser follower and spring should fit.
Usually the stamped followers can be ground down at the back to allow the bolt to close the same as the solid followers. Follower springs weakening are uncommon, though not unknown. Check www.gunpartscorp.com for the parts. Jim |
|
|