The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting > Bullet Casting

Thread Tools Search this Thread
Old August 28, 2009, 12:11 PM   #1
Join Date: August 3, 2009
Posts: 78
home made casting pot?

ok i have seen a few people make their own casting pots with a container of some kind and a heating element, normaly a a oven heating element. would pretty much any kind of wire stile heating element work? i want to make my own but i think 3500 watts is a bit much for my out buildings eletrical. most premade pots are using a 500 or 700 watt element, would that be ok? thanks

daleo8803 is offline  
Old August 28, 2009, 12:51 PM   #2
Senior Member
Join Date: April 6, 2009
Location: SWPA
Posts: 428
First off are you building this to cast with or to melt scrap down. If for Bullets you will need a way to adjust the temp, I melt my Wheel weights down with a Dutch oven over a propane heater. But cast with a Lee pot
hornady is offline  
Old August 28, 2009, 03:26 PM   #3
Senior Member
Join Date: August 1, 2007
Location: Tabor City , NC.
Posts: 1,971
i do my castin like hornady, but 500-700 would work .
the rcbs unit has 800 i think.

how ya gonna control the temp??
GP100man is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 03:38 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.06064 seconds with 10 queries