January 10, 2020, 05:24 PM | #1 |
Senior Member
Join Date: November 10, 2008
Location: East Texas
Posts: 1,326
|
Kimber Micro 9 Sights
I took my Kimber Micro 9 to a local gunsmith to have them order and install tritium night sights. Long story short: 2 weeks and some bad business practices later I finally have my slide and my money back. However, they removed or partially removed the old sights, leaving the weapon in a less than desirable condition. And I still need night sights installed.
Should I send it in to Kimber and have them do it? Should I take it to another gunsmith? (There are a couple of other local folks I trust left) Should I do it myself? I’ve built a few AR’s and have decent mechanical skills. If so is there a good sight pusher or other tool I should get? I don’t mind spending the money, especially if it’s on a tool I can use on several different guns. Thanks!
__________________
“Nature intended me for the tranquil pursuits of science, by rendering them my supreme delight.” - Thomas Jefferson Last edited by scorpion_tyr; January 10, 2020 at 05:24 PM. Reason: Auto correct is dumb |
January 10, 2020, 07:05 PM | #2 |
Senior Member
Join Date: October 19, 2005
Location: Tx Panhandle Territory
Posts: 4,159
|
I would seriously consider sending it back to it's home planet. Kimber doesn't monkey around with how tight they manage to fit their sights. It's my understanding that almost any other manufacturer has easier to replace sights than Kimber, so that might not be the best place for you to cut your sight changing teeth IMHO.
__________________
Rednecks... Keeping the woods critter-free since March 2, 1836. (TX Independence Day) I suspect a thing or two... because I've seen a thing or two. |
January 10, 2020, 07:32 PM | #3 |
Staff
Join Date: November 2, 1998
Location: Colorado
Posts: 21,824
|
I'm not familiar with the Micro9. If it has to be staked in and it's a tritium night sight, send it to Kimber.
__________________
Vigilantibus et non dormientibus jura subveniunt. Molon Labe! |
Thread Tools | Search this Thread |
|
|