The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old July 24, 2019, 04:10 AM   #1
Nathan
Senior Member
 
Join Date: July 1, 2001
Posts: 4,881
Anybody loading 458 Lott?

What do you recommend? Powders, tips, tricks, loads?


I’m looking to start with some light 300gr loads and work my way into 500 gr stopping rounds!

What dies are you using? How are you trimming?
Nathan is offline  
Old November 28, 2019, 08:30 AM   #2
Nathan
Senior Member
 
Join Date: July 1, 2001
Posts: 4,881
I’ll add a tip....Load development for a DG class round is a lot different than for a 7mm mag or something. The recoil is unbelievable! With moderate loads, I can shoot 10 shots in a session! Shooting is done standing up. I need to try the lead sled!

I find myself focused on confirming recoil, case pressure signs and bolt lift. I really don’t want to have noticeable bolt lift because in the field, I’ll be lifting it when something is charging! I will confirm velocities next.

Once I get past the recoil shock, I’ll need to work on groups....although minute of Buffalo is kind of the purpose here!
Nathan is offline  
Old November 28, 2019, 02:53 PM   #3
std7mag
Senior Member
 
Join Date: June 23, 2013
Location: Central Taxylvania..
Posts: 2,845
Unfortunately i live/hunt in PA.
But even if i do eventually get to move to WY, i still would have no need for a DGS gun of that caliber.
Largest i'm shooting now is 7mm Rem Mag.
Largest i would want to shoot is 7mm Dakota.
I guess i value my shoulder too much.

Ditch the lead sled! Only serves to create bad habits!
__________________
This country was founded on two beliefs.
And I'm pretty sure pork rinds was one of them!
std7mag is offline  
Old November 29, 2019, 10:24 PM   #4
44 AMP
Staff
 
Join Date: March 11, 2006
Location: Upper US
Posts: 20,854
Something that may never apply if you don't go on safari. but take a look at the pressures of the "classic" DGR rounds from the big hunting era. Comparatively low to allow for the increase when the ammo spends time in the 100+ degree tropical heat. One of he last things you want in a DGR is a stuck case due to high pressure caused by the high temps found where the elephant rifle is most commonly used.

So if you're working up to top end loads, do so in hot weather. You'll get a bit less in the cold but you'll be safe in the heat.
__________________
All else being equal (and it almost never is) bigger bullets tend to work better.
44 AMP is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:40 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.04090 seconds with 10 queries