The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools Search this Thread
Old March 3, 2000, 10:30 AM   #1
Tom B
Senior Member
 
Join Date: February 16, 1999
Location: GA
Posts: 1,836
How do you remove the original buckhorn sight from a Winchester 94 if you wish to install an aftermarket peep sight? Thanks.
Tom B is offline  
Old March 3, 2000, 11:01 PM   #2
cjb
Senior Member
 
Join Date: January 27, 2000
Posts: 265
I'm assuming you are talking about the rear ramp type sights. The cheapest way( without buying a sight pusher) is to pull out the elevating ramp. Then use a NYLON punch to "tap" the sight out of the dove tail. These punches are sold in a set for a few bucks from BROWNELLS. hold the punch at the base of the dove tail, and tap it to one side. If it dosen't move try the other way. They normaly come out easier the same way they went in.Be careful not to miss and WHACK the barrel!!! You may want to invest a few more bucks on a nylon hammer! All of these tools have many uses when it comes to firearms. Good luck!
(you may also want to order a dovetail blank, unless the peeps use the same dovetail)
CJB
cjb is offline  
Old March 4, 2000, 02:20 AM   #3
skyolsen
Junior Member
 
Join Date: February 17, 2000
Posts: 6
I've always had best results clamping the barrel in a padded vise as close to the sight as possible. That will be right in front of the forearm. Then, using a brass punch drive out the sight from left to right as you stand to the rear of the gun.
skyolsen is offline  
Old January 5, 2020, 07:44 PM   #4
pcxxxx42
Member
 
Join Date: August 28, 2012
Location: In AZ, Where Free Men Live
Posts: 18
Yes, but is the direction IMPORTANT?

I've read that as you stand behind the weapon, drift it LEFT to RIGHT?

Comments?

I'm about to undertake this project mesef.

mac
__________________
NRA & CRPA Life Member for over 30 years
pcxxxx42 is offline  
Old January 5, 2020, 08:02 PM   #5
Pahoo
Senior Member
 
Join Date: February 16, 2006
Location: IOWA
Posts: 7,794
Left to Right ???

Quote:
I've read that as you stand behind the weapon, drift it LEFT to RIGHT?
That is the common direction. However, If you don't know it's history then study the area and see it you can tell when direction was last used. I have seen some installed in the opposite direction. You can tell a lot by looking for signs that somebody left for you to read. A friend of mine once showed me his Grandfathers old SXS shotgun. I asked him is his Grandfather was let handed. His looked surprised how I knew. Pretty obvious. …..

Be Safe !!!
__________________
'Fundamental truths' are easy to recognize because they are verified daily through simple observation and thus, require no testing.
Pahoo is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:34 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05764 seconds with 10 queries