May 7, 2009, 01:12 AM | #1 |
Senior Member
Join Date: February 4, 2008
Posts: 200
|
Jewelling
I have a 3 screw Ruger 357 Blackhawk that is in excellent condition. It is original except for the jeweled hammer and trigger. I wanted to send it back to the factory for the safety conversion but realized that they would install a new hammer and trigger that would not be jeweled. Would it cost alot to have this done at the factory with my conversion? How much would a smith charge me afterward? I'm pretty sure my father could do it for me..what all would I need to buy for him to do it?
Any info. appreciated.........sixgunluvr |
May 7, 2009, 02:47 AM | #2 |
Senior Member
Join Date: January 26, 2009
Posts: 492
|
DON"T convert it, it is worth more without the conversion than with it. If you wanted the transfer bar sell that 3 screw and buy a new Ruger, you'll be money ahead. Jeweling for the trigger and hammer would run about $50 depends on who you went to.
|
May 9, 2009, 01:21 AM | #3 |
Senior Member
Join Date: February 4, 2008
Posts: 200
|
Re: 3 Screw
In that case I would like to have a Ruger Super BlackHawk .44 mag stainless with 10.5in barrel. Would an even up trade be fair if both are in good-excellent condition?
|
May 9, 2009, 06:16 PM | #4 |
Member In Memoriam
Join Date: March 17, 1999
Posts: 24,383
|
I doubt Ruger would do it, since they don't (AFAIK) offer jewelling as a factory option. Brownells has the equipment; basically you need a drill press and a means of holding the work and moving it in increments, like a drill press vise.
Jim |
May 21, 2009, 08:57 PM | #5 |
Senior Member
Join Date: December 17, 2005
Location: Swamp dweller
Posts: 6,187
|
Brownells sells jewelling kits. The kit come with everything you need
http://www.brownells.com/aspx/ns/sto...0TURNING%20KIT
__________________
NRA Life Member, NRA Chief Range Safety Officer, NRA Certified Pistol Instructor,, USPSA & Steel Challange NROI Range Officer, ICORE Range Officer, ,MAG 40 Graduate As you are, I once was, As I am, You will be. Last edited by Don P; May 21, 2009 at 09:03 PM. Reason: adding a link |
Thread Tools | Search this Thread |
|
|