The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools Search this Thread
Old November 29, 2018, 12:41 PM   #1
Roamin_Wade
Junior member
 
Join Date: July 11, 2018
Location: Baytown, TX
Posts: 220
11mm or 3/8” Scope Grooves

Are 11mm and 3/8” scope ring grooves the same? Put another way, can I install rings labeled 11mm on 3/8” grooves or vice-versa? I googled it but it started talking about grooves being cut at different angles so I decided to just ask in here so I can get firsthand knowledge. Thanks...
Roamin_Wade is offline  
Old November 29, 2018, 03:04 PM   #2
T. O'Heir
Senior Member
 
Join Date: February 13, 2002
Location: Canada
Posts: 10,939
Nope. 11mm is 7/16". 3/8" is 9.5mm. Mind you, the difference isn't much so they might fit.
__________________
Spelling and grammar count!
T. O'Heir is offline  
Old November 29, 2018, 03:30 PM   #3
NoSecondBest
Senior Member
 
Join Date: December 7, 2009
Location: Western New York
Posts: 2,287
Warne makes rings that can go either way simply by changing the orientation of the blocks on the bottom of the ring base. There is a difference in size and this comes up with European rifles more than here in the U.S. Example: Anschutz and CZ are 11mm. Warne p.n. is 721 and they come in different heights.
NoSecondBest is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:25 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.03991 seconds with 10 queries