|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
October 5, 2008, 11:44 AM | #1 |
Senior Member
Join Date: August 15, 2007
Posts: 1,040
|
Browning recoil pad removal
What size/type of screws hold the recoil pad on a BPS? I see the slits in the rubber where the screws should be but I can't tell what they are by feel . Thanks.
|
October 6, 2008, 01:42 AM | #2 |
Senior Member
Join Date: September 26, 2008
Location: Idaho- Where Else?
Posts: 130
|
I believe most of the recoil pads I've delt with were a large phillips head, but you'll just have to get in there with a couple different screw drivers and figure out which one fits into the screw. using an assembly type lube really helps when installing or removing pads, as it keeps the rubber from grabbing the driver, and helps get the screw out/in. Brownells sells it, but something similar, like a vynal conditioner would probably work too.
|
|
|