September 24, 2012, 12:45 PM | #1 |
Junior Member
Join Date: September 24, 2012
Posts: 3
|
Sig 1911 RCS Grips
Help with finding rubber grips for my Sig RCS
Thanks |
September 24, 2012, 01:34 PM | #2 |
Senior Member
Join Date: March 4, 2011
Location: Frisco, TX
Posts: 330
|
http://www.midwayusa.com/product/115...s-1911-officer
Their officer grips, so any with that label should fit it. |
September 24, 2012, 01:47 PM | #3 |
Senior Member
Join Date: May 10, 2007
Location: AZ
Posts: 270
|
and if you don't want finger groove ones, try these:
http://www.pearcegrip.com/Products/Colt/PG-OM2 The only problem you will most likely run into going with either one, is that you will most likely need to acquire full length 1911 grip screws. Remember, the RCS model (both the all black one and the two-tone one) comes with thin grips and thin grip bushings inserted into the frame (which means you currently have thin grip length (short) grip screws). You should be alright keeping the thin grip bushings (shouldn't have to change out the bushings), but will most likely have to get some normal full length 1911 black allen head grip screws to accommodate the normal thickness of the rubber grip panels. Hope this helps. I have the two-tone Sig 1911 RCS model myself. Great pistol. Good luck. Last edited by AZGlock13; September 24, 2012 at 01:59 PM. |
September 24, 2012, 02:36 PM | #4 |
Junior Member
Join Date: September 24, 2012
Posts: 3
|
Thankyou!!
thanks for your help, I guess if I order normal 1911 screws they will be long enough to work with those grips. Great Pistol!!!!
|
Thread Tools | Search this Thread |
|
|