March 23, 2013, 05:21 AM | #1 |
Junior Member
Join Date: March 22, 2013
Posts: 2
|
reload
i have a herters mod. 900 shot shell reloader can any one
tell me where i can get 20ga. dies for it |
March 23, 2013, 08:26 AM | #2 |
Staff
Join Date: July 28, 2010
Location: Arkansas
Posts: 8,821
|
Welcome to TFL, net!
You've put your thread in the General Discussion forum, but I'm going to send it off to our Reloading forums. I think you'll get better responses there. Cordially, Spats
__________________
I'm a lawyer, but I'm not your lawyer. If you need some honest-to-goodness legal advice, go buy some. |
March 23, 2013, 09:52 AM | #3 |
Junior member
Join Date: December 20, 2012
Location: The "Gunshine State"
Posts: 1,981
|
maybe on Ebay - that unit is decades old;
otherwise post a WTB on www.shotgunworld.com |
March 23, 2013, 10:24 AM | #4 |
Senior Member
Join Date: May 20, 2001
Location: Oshkosh wi.
Posts: 3,055
|
Quit foolin' around with antique junk!
Find a used MEC 600 jr., then you'll have a great loader that has parts available direct from MEC. Somebody is going to come along, advise you to buy a Lee load-all in 20 gauge. That too will work. Parts for that very old Herters loader that may NOT have been made in 20 gauge, will be nearly impossible to find.
__________________
The more people I meet, the more I love my dog They're going to get their butts kicked over there this election. How come people can't spell and use words correctly? |
March 23, 2013, 10:39 AM | #5 |
Senior Member
Join Date: May 3, 2011
Posts: 325
|
Re: reload
I use a load all 2 and several of the lee handloaders for shotguns. Have a mec somewhere too. Got 20, 12, and 10 gauges
|
March 23, 2013, 01:16 PM | #6 |
Junior member
Join Date: December 20, 2012
Location: The "Gunshine State"
Posts: 1,981
|
If you are going to be loading more than a few boxes, skip the zinc/plastic Lee. You cannot adjust it at all for crimp or wad seating, the hoppers can't be drained without unbolting the unit from the bench, and on and on.
For about $75, you can get a used MEC Jr. that will last you, your kids and their kids' lifetimes - check the bulletin board at your local trap/skeet club |
March 24, 2013, 08:03 AM | #7 |
Junior Member
Join Date: March 22, 2013
Posts: 2
|
hetrers
Thanks i will follow the advice.
|
|
|