Hs 2000

railroader · August 4, 2001, 05:38 PM

I have a new hs 2000. It is a polymer pistol somewhat similar to a glock. It has a pin that holds mag release assembly in the gun. The pin goes completely through the frame above the mag release button. After firing about 100 rounds the pin walks out of the frame about a sixteenth of a inch. I have shot the pistol twice and it has happened twice. I know how to tighten up a pin in a steel gun but being this gun is new and polymer I really didn't want peen( I quess you would call it) the pin. Would maybe a drop of locktite work on each end of the pin work? Thanks, Mark.

August 4, 2001, 05:38 PM	#1
railroader Senior Member Join Date: February 8, 2000 Location: Tucson Arizona Posts: 1,756	Hs 2000, pin problem I have a new hs 2000. It is a polymer pistol somewhat similar to a glock. It has a pin that holds mag release assembly in the gun. The pin goes completely through the frame above the mag release button. After firing about 100 rounds the pin walks out of the frame about a sixteenth of a inch. I have shot the pistol twice and it has happened twice. I know how to tighten up a pin in a steel gun but being this gun is new and polymer I really didn't want peen( I quess you would call it) the pin. Would maybe a drop of locktite work on each end of the pin work? Thanks, Mark. Last edited by railroader; August 4, 2001 at 10:13 PM.