|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
February 23, 2015, 05:08 PM | #1 |
Member
Join Date: January 6, 2009
Posts: 89
|
Finallt found a new buttstock for Steven Little Scout!
Now I need to fit it to the receiver and sand it down. What # cabinet rasp would be good for the final fitting, maybe 1/8th inch at most will need to be taken off. Advice.....
|
February 26, 2015, 01:18 PM | #2 |
Staff
Join Date: November 2, 1998
Location: Colorado
Posts: 21,831
|
#50 Nicholson. Go slow. Use a 12" ruler to ensure it is level or to identify the high spot. Then sand.
__________________
Vigilantibus et non dormientibus jura subveniunt. Molon Labe! |
February 26, 2015, 06:20 PM | #3 | |
Senior Member
Join Date: August 25, 2008
Location: In the valley above the plain
Posts: 13,424
|
Quote:
I have two metal "straight edge" rulers on my bench, as I type this. Both are bowed by 0.015" to 0.020". One "straight" edge is convex. The other "straight" edge is concave.
__________________
Don't even try it. It's even worse than the internet would lead you to believe. |
|
|
|