November 19, 2004, 06:22 PM | #1 |
Junior Member
Join Date: October 28, 2004
Posts: 13
|
Ruger Vaqero
Can anyone tell me what the .45 long colt vaqero's are sighted in with at the factory. I have one in 3.5 in barrel stainless. I think is should group better.
Waddy |
November 23, 2004, 07:06 PM | #2 |
Senior Member
Join Date: August 13, 2004
Location: Montana
Posts: 226
|
Where in Montana are you? Which Vaquero do you have? I have several, I
have a Birdhead Vaquero that I am shooting nice groups out of with 300 grain hard cast bullets and 25 grains of H110. |
December 26, 2004, 10:44 PM | #3 |
Senior Member
Join Date: December 14, 2004
Location: Northern Indiana
Posts: 6,117
|
I have a 5 inch myself
And altho it functions without error I think it was sighted at the factory about 4 inches to the right.
I had a good friend of my (a good gun smith) bend the front sight. Took 2 tries to get it right and then it hit 2 inches low at 15 yards. I diddnt mess with that. I have heard from other people that have owned Vaquro say the same thing. I dont think that Ruger is doing enough to get everything aligned. The other thing that I diddnt like about them was the grips. The fit was VERY poor. Even if it was only a 450 dollar gun I expect better than this. Ruger builds very strong and good functioning guns, they just need to work on there fit and finish a little more. |
|
|