|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
|
Thread Tools | Search this Thread |
September 30, 2017, 07:32 PM | #1 |
Senior Member
Join Date: September 2, 2017
Location: SE Kansas
Posts: 116
|
thompson center stock set won't fit
Hey all I received my TC walnut stock and forearm today that I ordered off of Ebay. The seller said it came off of his pro hunter barrel. After I removed my flex tech forearm I tried to put my new one on my Katahdin pro hunter barrel and it doesn't fit quite right. I think that the screw hole in the new forearm is recessed deeper because when I tighten the screws the fore arm will still move up and down. Maybe i could put a few washers on the screws to shorten them up? Do i need to buy new screws? The screws I have now are both the same length. Any help is appreciated.
|
September 30, 2017, 08:31 PM | #2 |
Junior member
Join Date: May 16, 2008
Posts: 9,995
|
Welcome to the club. The, 'I thought this was just drop the barrel in' club.
http://www.encoreclassifieds.com/forum/ http://specialtypistols.infopop.cc/eve/forums The individuals at those two forums can answer most any TC question CORRECTLY. |
September 30, 2017, 11:23 PM | #3 |
Senior Member
Join Date: September 2, 2017
Location: SE Kansas
Posts: 116
|
Thank you. That's just what I was looking for
|
Thread Tools | Search this Thread |
|
|