|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
|
Thread Tools | Search this Thread |
January 13, 2015, 09:39 AM | #76 |
Senior Member
Join Date: December 2, 2006
Posts: 122
|
Don't know about Starline brass, but my Nagant has no problem with Remington and Winchester .32-20 brass. No need to thin the rims. Depends upon the particular gun I guess?
Paid less than a C-note for mine, but that was a good many years ago. ALL guns have gone up. A certain semiauto rifle I bought for $375 (which was high then!) is going for over six bills now. ANYTHING with any real historical interest is climbing fast. |
January 13, 2015, 09:39 AM | #77 |
Junior member
Join Date: October 4, 2007
Location: All the way to NEBRASKA
Posts: 8,722
|
I must be doing something wrong with the .312" XTP's then ..... they seemed to work.
|
January 13, 2015, 10:06 AM | #78 | |
Senior Member
Join Date: September 28, 2013
Posts: 3,769
|
Quote:
With 0.312" bullet I had to trim the brass way back (no seal). It worked alright. But the 0.308" bullet with seal gave me much better group with 20% more speed. Besides 30 carbine bullets are cheap, about 10 cents a round, and I have a lot of them. Regardless, point is hand loads with gas seal is doable with good results. It is not that hard either. -TL |
|
January 13, 2015, 10:40 AM | #79 | |
Member
Join Date: December 10, 2011
Posts: 67
|
Quote:
__________________
The GunStockMarket |
|
January 13, 2015, 10:46 AM | #80 | |
Senior Member
Join Date: September 28, 2013
Posts: 3,769
|
Quote:
-TL |
|
Thread Tools | Search this Thread |
|
|