The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Hunt

Reply
 
Thread Tools Search this Thread
Old July 3, 2007, 03:21 PM   #1
steelrat
Member
 
Join Date: February 8, 2007
Location: Utah
Posts: 66
30-06 Elk Round

What is the best weight of bullet to get for a 30-06 to take elk? Looks like they range anywhere from 150-Grain to 220-Grain. What's the difference between them?
steelrat is offline  
Old July 3, 2007, 03:32 PM   #2
davlandrum
Senior Member
 
Join Date: February 27, 2006
Location: Lane County Oregon
Posts: 2,547
weight

I like Rem Premier Accu-Tip 180 grain. They shoot well for me. I like 165 grain for Mule deer, although 150's would work just as well.
davlandrum is offline  
Old July 3, 2007, 03:35 PM   #3
armedandsafe
Senior Member
 
Join Date: January 9, 2005
Location: Moses Lake WA
Posts: 1,001
I have always used the 180gr Sierra SPBT. I've taken deer, elk, antelope, moose and black bear with them and found them very good bullets.

I took my Barren Ground Grizzley and my Polar Bear with the 220 Barnes. One shot each, by being verrrrry lucky.

Generally speaking, the lighter bullets are for greater velocity (therefore greater range for pointblank zero) and smaller animals. I have used the 180s for rockchucks, but the 168s or 150s are a little better for long shots.

Pops
__________________
Armed and Safe: Not just a theory

If it time to bury them, it is time to dig them up.
Remember, "Behind every blade of grass."
armedandsafe is offline  
Old July 3, 2007, 04:08 PM   #4
taylorce1
Senior Member
 
Join Date: November 18, 2005
Location: On the Santa Fe Trail
Posts: 8,207
I think if you use 180 grain and heavier you can get by without using a premium bullet on elk. If you go with 150 or 165 grain I think you would be better served by a bonded core, Partition, or Barnes bullet. I've had great luck with the Nosler Partition in 150 grain on elk from my .270 Win.
taylorce1 is offline  
Old July 3, 2007, 05:28 PM   #5
davlandrum
Senior Member
 
Join Date: February 27, 2006
Location: Lane County Oregon
Posts: 2,547
My buddy is working up loads using the Nosler Accu-bond 165s. That may become my "do-it-all" round (not planning on polar/grizzly hunting in the near future).

I was concerned when I started about having enough punch with the 165s on elk, but now admit, they probably have plenty of juice (good bullet constructions, good shot placement, etc)
davlandrum is offline  
Old July 3, 2007, 10:16 PM   #6
crowbeaner
Senior Member
 
Join Date: June 4, 2007
Location: Upstate SC
Posts: 1,943
I will probably never get to go elk hunting, but I sure would not want to go with an unproven bullet. Nosler Partition 180 gr. 30/06 and 48.0 of IMR 4064.
crowbeaner is offline  
Old July 3, 2007, 11:35 PM   #7
FirstFreedom
Junior member
 
Join Date: May 31, 2004
Location: The Toll Road State, U.S.A.
Posts: 12,451
Most any 180 or 220, or a premium (bonded or partition) 165 will do if you do.

Federal has some nice choices in it's premium line (Vital-shok), in 180s:

-Nosler Accubond
-Barnes TSX
-Barnes MRX
-Nosler Partition
-Nosler Partition - HE (high energy - higher velocity rounds - turnbolt only)
-Trophy Bonded Bear Claw
-Trophy Bonded Bear Claw - HE (excellent choice)
FirstFreedom is offline  
Old July 11, 2007, 06:53 PM   #8
Jack O'Conner
Senior Member
 
Join Date: July 11, 2005
Location: Manatee County, Florida
Posts: 1,974
Local stores sell stacks and stacks of 180 grain Remington core-lockt ammo every Fall to local elk hunters. There are many guys who fill their freezers filled annually with premium elk steaks hunting with 30-30 carbines but its supposed to be a secret.

Jack
__________________
Fire up the grill! Deer hunting IS NOT catch and release.
Jack O'Conner is offline  
Old July 12, 2007, 08:31 AM   #9
ZeroJunk
Senior Member
 
Join Date: August 14, 2006
Location: Browns Summit NC
Posts: 2,589
I got my first rag horn with a 150 grain Sierra BTSP.He fell where he stood.Consensus of opinion is that you should use a bigger better bullet.Now I use 165 grain Nosler Partitions.If you slam something in to the heavy front shoulder of a big bull you may wish you had used something heavier than that.
ZeroJunk is offline  
Old July 14, 2007, 08:25 PM   #10
Ifishsum
Senior Member
 
Join Date: September 15, 2005
Location: Oregon
Posts: 1,033
I've heard a lot of people say they use 150 for deer and 180 for elk. Fine, except that you have to rezero your rifle whenever you change loads, and many do not. Besides, if 180 will kill an elk it will kill a deer. I personally use a quality 165 gr bullet for both and it has worked well for me so far, never had to shoot an animal more than once. Shot placement is the most important factor at any rate.
Ifishsum is offline  
Old July 15, 2007, 12:47 PM   #11
Art Eatman
Staff in Memoriam
 
Join Date: November 13, 1998
Location: Terlingua, TX; Thomasville, GA
Posts: 24,798
Based solely on the depth and size of the imprints on steel at 500 yards from my .30-'06 and Sierra bullets:

The 150-grain SPBT made a slight indentation.

The 165-grain HPBT made a bit deeper indentation.

The 180-grain SPBT made an indentation twice as deep as the 165. The mini-crater area was also twice as wide, with some splash-back of the steel.

From this I conclude that the 180-grain bullet would be best for deeper penetration in the event of an angling shot on a large animal.

It is further my opinion that the R&D in bullet construction has it that nowadays in 30-caliber, the 180 penetrates as well as the 220-grain bullets of "yesteryear". For all practical purposes, anyway.

Art
Art Eatman is offline  
Old July 17, 2007, 05:28 PM   #12
Zombie Steve
Senior Member
 
Join Date: June 3, 2007
Location: Old Colorado City
Posts: 527
Do your part and a 180 grain load will work just fine.
Zombie Steve is offline  
Old August 1, 2007, 10:56 PM   #13
7mm-08
Member
 
Join Date: February 17, 2006
Location: Selkirk,Manitoba
Posts: 43
I have only dropped one elk and she fell to a Winchester 180gr. power point.I have used 180gr nosler partiton,180gr Hornady light magnum.But the power point worked best for me.
7mm-08 is offline  
Old August 8, 2007, 09:42 AM   #14
tyrajam
Senior Member
 
Join Date: July 24, 2007
Location: Indianapolis, IN
Posts: 467
I'm a big fan of the 180gr nosler partition. I think federal has some new Heavy Energy '06 loads, 180gr at 2880fps if I remember right. I havn't shot them yet, but might be worth checking out.
tyrajam is offline  
Old August 8, 2007, 10:10 AM   #15
Charles S
Senior Member
 
Join Date: July 29, 2002
Location: North East Texas
Posts: 950
Ah..finally sensible caliber selection for elk..

Honestly I like the 180 gr bullets for animals that large. The premium 165s will work just fine also.

I however will assert that the premium 180s like Barnes, Nolser, and Swift allow the shooter to take tougher shots like quartering away with greater confidence due to their potential for higher weight retention and deeper penetration. Also the newer premium loadings like the Barnes triple shock, Nolser Accubond, and Swift Scirroco have higher ballistic coeffecients giving the hunter a few more yards of range (a greater maximum point blank range).

Honestly any of the 180 grain 30-06 loads (just as Jack stated) will work just fine.
__________________
"People sleep peaceably in their beds at night only because rough men stand ready to do violence on their behalf." -- George Orwell
Charles S is offline  
Old August 17, 2007, 10:57 AM   #16
VirgilCaine
Senior Member
 
Join Date: October 29, 2004
Location: Northern Michigan
Posts: 419
180g Nosler partition. However, my evidence of efficacy is purely anecdotal... Hit 'em where your supposed to, they won't go far.
__________________
"Danger Itself Is The Best Remedy For Danger"
VirgilCaine is offline  
Old August 17, 2007, 02:47 PM   #17
Bottom Gun
Senior Member
 
Join Date: October 13, 1998
Location: Arizona Territory
Posts: 1,092
I've used Nosler partitions to take five elk. Three were taken with 180 gr partition in .30-06 and .308, two were taken with a 210 gr partition in .338.

None required more than one shot. I'm sold on Nosler Partitions.
Bottom Gun is offline  
Old August 18, 2007, 12:22 AM   #18
samsmix
Senior Member
 
Join Date: June 29, 2006
Location: Montana (Montucky?)
Posts: 1,273
+1 to Bottom Gun
__________________
You'll probably never NEED a gun. I hope you never do. But IF you do, you will need it worse than anything you've ever needed in your life.

IF we're not supposed to eat animals,
howcome God made 'em outta meat?
samsmix is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:46 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.09524 seconds with 10 queries