The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old January 14, 2013, 02:27 PM   #1
triker
Member
 
Join Date: January 15, 2011
Location: SW Iowa
Posts: 31
Loaded up a few 45 colt

Finally got some new brass, so loaded up a few. Unique, 7.5 gr, with 255 gr MBC, SWC and CCI 350 magnum primers (as these are all thats available here). Shooting them in a Ruger, Lipsey, SS 45 lc/acp convertible. Hope to test them out this week. That load sound safe enough to start with, even with the magnum primers? triker
triker is offline  
Old January 14, 2013, 11:53 PM   #2
Edward429451
Junior member
 
Join Date: November 12, 2000
Location: Colorado Springs, Colorado
Posts: 9,494
Your load will be fine. No danger there. Your significantly below max so the Mag primer shouldn't make a difference.
Edward429451 is offline  
Old January 15, 2013, 12:53 AM   #3
rclark
Senior Member
 
Join Date: February 12, 2009
Location: Butte, MT
Posts: 2,622
You'll be Jusssst fine .
__________________
A clinger and deplorable, MAGA, and life NRA member. When guns are outlawed, only outlaws will have guns. Single Action .45 Colt (Sometimes colloquially referred to by its alias as the .45 'Long' Colt or .45LC). Don't leave home without it. That said, the .44Spec is right up their too... but the .45 Colt is still the king.
rclark is offline  
Old January 15, 2013, 09:57 AM   #4
dodge
Senior Member
 
Join Date: July 10, 2001
Location: ridgerunner from Northern PA
Posts: 291
This will probably be a mild load. In my Ruger Blackhawk I use pretty much the same bullet, brass and primers but with a 10 grs of Unique and this is a very stout load that I worked up to. For general shooting I load up lighter loads using 8 grs of Unique.
dodge is offline  
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:02 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.03741 seconds with 10 queries