The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: General Handgun Forum

Reply
 
Thread Tools Search this Thread
Old November 9, 2017, 05:08 PM   #1
5pins
Senior Member
 
Join Date: October 30, 1998
Location: WV
Posts: 252
Hornady 135gr Critical Duty in Clear Ballistics gel.



Today I had the opportunity to shoot some Hornady 135gr FTX Critical Duty Into some 10% Clear Ballistics gel. Test pistol was a Sig P229 with a 4-inch barrel. The rounds where shot into two 16 inch blocks of Clear gel stacked back to back for a total of 32 inches.

The chrony didn’t pick up the velocity of the first round shot into the bare gel and it exited out of the side of the gel block at about 15 inches and expanded to .44 inches. The bullet was found on the floor after hitting the rubber backstop. Round two penetrated to 18 inches with a velocity of 977fps and expanded to .44 inches also. I decided to shoot a third round and it stopped at 18.5 inches, expanded to .46 inches with an impact velocity of 997fps.



The first, and only, round fired through heavy clothing completely passed through both gel block and was not recovered. At this point I decided to stop the test and save my gel for testing something else.
__________________
www.general-cartridge.com
5pins is offline  
Old November 9, 2017, 09:08 PM   #2
hubris
Senior Member
 
Join Date: February 3, 2013
Location: SE Tn
Posts: 122
My 9's like the 135 gr rounds as do I. It 'feels' more like a 45/230 push rather than the 9/115 snap. Easy to get back on target.
hubris is offline  
Old November 10, 2017, 01:21 AM   #3
armoredman
Senior Member
 
Join Date: May 22, 2007
Location: Arizona
Posts: 5,292
The Duty is meant for barrier penetration, so I'd expect good penetration. The Critical Defense is supposed to be a more all around defensive bullet. Have said that I do carry Critical Duty in my P-10C.
armoredman is offline  
Old November 10, 2017, 03:41 PM   #4
fastbolt
Senior Member
 
Join Date: June 9, 2002
Location: northern CA for a little while longer
Posts: 1,927
Those recovered bullets remind me of different 147gr loads I've seen tested over the years, fired from both duty & off-duty type pistols.

Consider that the load was developed by Hornady to fall within the FBI criteria for duty ammunition, using the FBI's testing protocols.

Here's the company's testing: http://www.hornadyle.com/products/ha...5-gr-9mm-luger

The +P version: http://www.hornadyle.com/products/ha...-gr-9mm-lugerp

I carry neither load, myself, but if it were issued I'd not lose sleep carrying it.

FWIW, the 115gr Critical defense load: http://www.hornadyle.com/products/ha...ger-115-gr-ftx

I only use the FTX bullets in the standard pressure 110gr .38 Spl load (to avoid stressing a pristine 37-2 Airweight), and the 45gr .22 MAG load.

If you're interested, you can download the Hornady Ammunition Test Report & Application Guide here: http://www.hornadyle.com/assets/site...tion-Guide.pdf
__________________
Retired LE - firearms instructor & armorer
fastbolt is offline  
Old November 10, 2017, 04:30 PM   #5
TruthTellers
Senior Member
 
Join Date: October 22, 2016
Posts: 3,869
Those 135's need more velocity to expand. Try them out of a 4.5 inch or longer barrel.

Yeah, I know that's a full sized gun, but that's what the police usually carry.
__________________
"We always think there's gonna be more time... then it runs out."
TruthTellers is offline  
Old November 10, 2017, 05:19 PM   #6
smee78
Senior Member
 
Join Date: July 14, 2008
Location: South Carolina
Posts: 2,918
I like the heaver 9mm bullets and tend to go with the 124-147grn bullets in my guns. The Hornady and the Speer Gold Dots are my go to rounds for self-defense ammo. Thanks for sharing your results with us.
__________________
We know exactly where one cow with Mad-cow-disease is located, among the millions and millions of cows in America, but we haven't got a clue where thousands of illegal immigrants and terrorists are
smee78 is offline  
Old November 15, 2017, 05:11 PM   #7
5pins
Senior Member
 
Join Date: October 30, 1998
Location: WV
Posts: 252
I became curious as to what would happen I the polymer plug was removed and if it would change its performance. I fired one shot into a bare Clear gel block at 10 feet. I didn’t set up the chrony but penetration decreased to 15 inches and expansion increased to .52 inches.

__________________
www.general-cartridge.com
5pins is offline  
Old November 17, 2017, 03:57 PM   #8
5pins
Senior Member
 
Join Date: October 30, 1998
Location: WV
Posts: 252
So I was able to shoot an unplugged round through heavy clothing this morning. It penetrated 16.5 inches. I forgot to measure the expansion but as you can see it opened up ok.

__________________
www.general-cartridge.com
5pins is offline  
Old November 19, 2017, 08:46 AM   #9
zeke
Senior Member
 
Join Date: November 17, 1999
Location: NW Wi
Posts: 1,664
5pins-Thanks for posting your test results! Find it interesting these expanding more with the plug removed, and most wouldn't have even thought of trying it.
zeke is offline  
Old November 20, 2017, 02:32 PM   #10
SA1911
Junior member
 
Join Date: September 6, 2017
Posts: 147
9pins,

If you're gonna use a 9MM for self-defense, use 147 grain Federal HST Tactical ammo.
SA1911 is offline  
Old November 20, 2017, 09:19 PM   #11
Charlie98
Senior Member
 
Join Date: September 6, 2006
Location: Great state of Texas
Posts: 1,077
I run the 135grn Hornady through my Kahrs... after looking at your results I may have to give it some thought because the barrels on my pistols aren't even 4". Oddly enough, I clocked it at 1025fps out of my CW9 (3.5") and 930fps out of my CM9 (3"). I used to carry Hornady 147grn Critical Defense until it disappeared off the shelves, and the 135grn Hornady was more accurate than Gold Dots.
Charlie98 is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:27 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.04770 seconds with 10 queries