The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools Search this Thread
Old August 19, 2017, 09:47 AM   #1
Jace242
Junior Member
 
Join Date: August 17, 2017
Posts: 1
Sig P938 front fiber optic sight

I had the front fiber optic rod fall out on a Sig P938 pistol and I'm trying to replace it. Every fiber optic I've replaced before has had holes on both the front and back end so I just have to cut it so it's a little oversized and melt both ends. The sig factory sight has no hole in the front so I only have access to the rear portion of the rod to burn it so there is nothing to prevent the the rod from being pulled out. What do I need to do to lock the rod into place?

Below is a link to the style of front sight I have.

https://www.sigsauer.com/store/media...-frt-tru-8.jpg
Jace242 is offline  
Old August 19, 2017, 01:08 PM   #2
Bill DeShivs
Senior Member
 
Join Date: April 7, 2006
Posts: 10,967
Glue.
__________________
Bill DeShivs, Master Cutler
www.billdeshivs.com
Bill DeShivs is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:55 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.03710 seconds with 10 queries