The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Reply
 
Thread Tools Search this Thread
Old September 6, 2019, 05:23 PM   #1
Winny
Senior Member
 
Join Date: June 12, 2018
Location: SC, USA
Posts: 134
Beretta AL391 Bolt Stuck

I am breaking down my Beretta AL391 and the bolt is stuck in the receiver. This has happened in the past due to the hammer being dropped which is not the case right now.

I cannot reassemble or disassemble the firearm right now as the bolt is “stuck” in place. Any suggestions?
Winny is offline  
Old September 6, 2019, 06:36 PM   #2
Winny
Senior Member
 
Join Date: June 12, 2018
Location: SC, USA
Posts: 134
UPDATE:

Pulled the trigger group out and the bolt came sliding out. Was able to clean and reassemble everything after. Not sure what it was hung up on but that bolt sure is a finicky little bugger.
Winny is offline  
Reply

Tags
al391 , beretta

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:46 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.03989 seconds with 8 queries