.45 Colt SAA Firing Pin

poko · December 16, 2007, 10:10 PM

Greetings:

New poster here. I have a question regarding my new 3rd gen. Colt SAA. If I need to seek the answer in another forum please direct me. I have a 2nd gen. Colt SAA and the firing pin on the hammer is fixed tight...doesn't move. On my newly acquired 3rd gen. Colt SAA the "pin" moves around a bit. Was this an upgrade specific to 3rd gen. SAA's or is this a defect? I shot the pistol todey and it shoots just fine.

Thanks,

Chuck

Rusty.it · December 17, 2007, 04:05 AM

it's just an easy way to get good alignment of the pin in his hole!
It's drive in by the conical part of it

Don't worry, my SAA by Pietta work in the same way and work well!
ciao
Rusty

December 16, 2007, 10:10 PM	#1
poko Member Join Date: December 16, 2007 Posts: 22	.45 Colt SAA Firing Pin Greetings: New poster here. I have a question regarding my new 3rd gen. Colt SAA. If I need to seek the answer in another forum please direct me. I have a 2nd gen. Colt SAA and the firing pin on the hammer is fixed tight...doesn't move. On my newly acquired 3rd gen. Colt SAA the "pin" moves around a bit. Was this an upgrade specific to 3rd gen. SAA's or is this a defect? I shot the pistol todey and it shoots just fine. Thanks, Chuck

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

December 17, 2007, 04:05 AM	#2
Rusty.it Member Join Date: May 29, 2007 Posts: 50	it's just an easy way to get good alignment of the pin in his hole! It's drive in by the conical part of it Don't worry, my SAA by Pietta work in the same way and work well! ciao Rusty