May 19, 2011, 10:50 PM | #1 |
Member
Join Date: December 29, 2009
Posts: 18
|
Gunsmithing tools
I am looking for a set of gunsmithing screw drivers like Wheeler Engineering or
others. I can't decide from reviews which one is best. I have many guns from surplus to 10-22. Any thoughts and advice would be appreciated, likes and dislikes. Thanks |
May 20, 2011, 10:03 AM | #2 |
Senior Member
Join Date: December 17, 2005
Location: Swamp dweller
Posts: 6,187
|
Wheeler is made in China and Brownells Magna-Tip screwdrivers are made in the USA. I have the Magna-Tip set and all is good. Its one reason the Wheeler set is inexpensive when compared to the Magna-Tip set/sets
__________________
NRA Life Member, NRA Chief Range Safety Officer, NRA Certified Pistol Instructor,, USPSA & Steel Challange NROI Range Officer, ICORE Range Officer, ,MAG 40 Graduate As you are, I once was, As I am, You will be. |
May 20, 2011, 11:17 AM | #3 |
Junior member
Join Date: February 2, 2008
Posts: 3,150
|
Choosing between Wheeler or Brownells - Brownells by a mile. Be sure to get at least one of the law Enforcement handles ( they're shorter) if you buy a set. Good tools cost more but perform better and last much longer.
|
May 20, 2011, 02:39 PM | #4 |
Member
Join Date: December 29, 2009
Posts: 18
|
Thank you very much for your advice. I will go with the more expensive ones you get what you pay for.
|
May 27, 2011, 09:44 AM | #5 |
Senior Member
Join Date: August 9, 2009
Location: Metro Atlanta Area
Posts: 125
|
Gunsmithing tool
with the Brownell's set you have a lifetime warranty. I had a bit break and emailed the part # this past Monday and yesterday(Thurs) a replacement rolled in. what great customer service. as an aside I have the wheeler set and constantly break bits and those are replaced by purchasing not by warranty. the Brownell's bit is also harder.
__________________
Small Arms Restoration, Inc. smallarmsrestoration.net Proud member of Georgia Carry.org www.georgiacarry.org |
|
|