The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: The Revolver Forum

Thread Tools Search this Thread
Old December 23, 2019, 01:52 AM   #1
Join Date: December 23, 2019
Location: South Carolina
Posts: 29
Webley Recoil Pad/Shield?

Looking for a Webley Mk VI recoil pad and screws. Does anyone know where I could buy one? In case you’re not sure what that is, I’ve included a link with a diagram of all Mk VI parts. That specific part is labeled as #19. Numrich is out of stock.
Holmes529 is offline  
Old December 23, 2019, 11:35 PM   #2
Senior Member
Join Date: September 2, 2001
Location: Out West in Rim Country
Posts: 961
Hello and welcome Holmes. The area of the firing pin hole was damaged on my MK VI. I had to keep looking for a while. Gunpartscorp had one, but when I got it it was evident that someone had already tried to repair the same problem by brazing. That would not have been durable. Gunparts refunded my money without any problem. I kept looking, and at some point located a good one at Jack First, IIRC. So were I still looking for a recoil shield, I would keep doing what I did; checking, Numrich, Jack First, Gunbroker, Ebay, and anywhere else I could think of. When some of these obsolete parts pop up, there may be only one available, so if you're not regularly checking, you may miss it. Good luck in your search.
COTEP 640, NRA Life
rock185 is offline  
Old December 24, 2019, 09:27 PM   #3
44 AMP
Join Date: March 11, 2006
Location: Upper US
Posts: 22,169
Link not working for me..

Webley parts are where, and as you find them. Essentially they only come from dismantled Webleys these days.

Good Luck!
All else being equal (and it almost never is) bigger bullets tend to work better.
44 AMP is online now  

mk vi , recoil pad , webley

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 09:20 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2020 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.03822 seconds with 8 queries