The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old March 14, 2018, 08:31 AM   #1
Junior Member
Join Date: July 9, 2006
Location: Princeton, NJ
Posts: 13
Hornady AP Projector press?

I have a chance to pick up a NON Lock and Load Hornady AP Projector press with one set of dies and two extra shell plates for $200. I am presently using a Lee Pro 1000. My question is whether $200 is a good price for that press? Is the press an outdated model, that will be a white elephant?
mcgiiver is offline  
Old March 14, 2018, 06:47 PM   #2
Senior Member
Join Date: February 20, 2015
Location: Brandon Fl
Posts: 189
Sure it’ll work fine mate,plus you could use it as a trade for a LNL

THEWELSHM is offline  
Old March 15, 2018, 11:25 AM   #3
Senior Member
Join Date: September 6, 2006
Location: Great state of Texas
Posts: 1,075
I still have my ProJector... the predecessor to the LNL. I prefer it over the LNL setup, I don't care for the collets.

Parts are getting a little scarce, but they take the same shell plates as the LNL, so you aren't limited to what comes with it.

In the 25 years I've been loading on my ProJector, I've never replaced one part. About every 10 years I tear it down, grease everything up and tune it a bit, no problems whatsoever.

"I have this pistol pointed at your heart!"
"That is my least vulnerable spot."
Charlie98 is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 04:05 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2020 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Page generated in 0.04794 seconds with 10 queries