The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old May 30, 2007, 02:48 AM   #1
beaver
Senior Member
 
Join Date: May 29, 2007
Posts: 118
.357 Sig

New to reloading and am looking at a lee turret press would this be a good set up to use and which dies would i need to load .357 sig

Last edited by beaver; May 30, 2007 at 03:07 AM. Reason: missing words
beaver is offline  
Old May 30, 2007, 07:14 AM   #2
Dave P
Senior Member
 
Join Date: August 16, 1999
Location: North Florida
Posts: 1,346
cast iron press is fine. Get the 3 piece die set, and the factory crimp die is also critical.

Follow published loads!
Dave P is offline  
Old May 30, 2007, 09:04 AM   #3
Overhill
Member
 
Join Date: March 1, 2007
Location: PA
Posts: 96
Ditto on the factory crimp die. Also, flare the case just enough to start the bullet. No more.
Overhill is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:07 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.04084 seconds with 8 queries