July 20, 2012, 12:48 PM | #1 |
Senior Member
Join Date: March 21, 2006
Location: marlow okla
Posts: 227
|
loading 380
i have a lyman 1200 dps powder dispenser and loading 3.2 gr hp 38 the cases are so small that my reg. funnel , when casses are sitting in loading block, doesent go down for enough to keep from spilling powder when filling cases. any ideas? thanks cjs
|
July 20, 2012, 04:51 PM | #2 |
Member
Join Date: May 3, 2011
Location: Littleton Colorado
Posts: 78
|
I use a 2x4 and a paddle bit 3/4 inch and drill down 3/8 inch doing 20 or 30 holes in the 2x4 and use a spare funnel i have filed off 1/8 inch and have no problems with either 380 or 9mm. The funnel will fit into the 3/4 inch hole to keep it in place. Charlie
|
July 20, 2012, 06:06 PM | #3 |
Senior Member
Join Date: April 11, 2008
Posts: 197
|
The MTW universal load block is one of my most often used tools. You can almost always find a hole that allows the funnel to work.
|
July 22, 2012, 09:04 AM | #4 |
Senior Member
Join Date: March 21, 2006
Location: marlow okla
Posts: 227
|
loading block
thsnks fellows, some good ideas cjws
|
|
|