questions about a ak47

chadstrickland · April 20, 2011, 04:26 PM

Lol ok..I had this posted in the rifle thing but then it dawned on me that may have not been the correct place to post..so ill do it on both..I was wondering if I could use some of my romanian ak47 parts kits I got layin around the house and use one of those nodakspud receivers...( which they are hungarian ) so can my parts go in that receiver or not..and if some will and some wont..which will go and which wont...I dnt know if the pin holes are the same diameter or not..idk..

Dfariswheel · April 20, 2011, 05:47 PM

As long as you have an unfinished NoDak Spud receiver, most any AK parts will fit.
Where you might have trouble is with a receiver that's already had the trunnion holes drilled and won't line up with whatever kit you have.

chadstrickland · April 21, 2011, 10:57 AM

Thanks dude...ill have to check and see...if not I have the drawing for a romanian receiver...but im still not sure..if the holes are far enoug away from each other that I could drill new ones without cutting into the original holes....thanks tho

5.45 Shooter · April 26, 2011, 10:27 PM

As long as your receiver is not the Hungarian AMD 65 it will fit.
If it is the AMD 65 the only diferance is the rear trunnion.

April 20, 2011, 04:26 PM	#1
chadstrickland Senior Member Join Date: January 26, 2011 Location: alabama Posts: 537	questions about a ak47 Lol ok..I had this posted in the rifle thing but then it dawned on me that may have not been the correct place to post..so ill do it on both..I was wondering if I could use some of my romanian ak47 parts kits I got layin around the house and use one of those nodakspud receivers...( which they are hungarian ) so can my parts go in that receiver or not..and if some will and some wont..which will go and which wont...I dnt know if the pin holes are the same diameter or not..idk.. __________________ Two weapons that was designed by the same man still in use by the us military 100 years later...1911 and m2...is there anything that comes close.....lol annd maybe perhaps a sig sauer p226 tac ops edition..

April 21, 2011, 10:57 AM	#3
chadstrickland Senior Member Join Date: January 26, 2011 Location: alabama Posts: 537	Thanks dude...ill have to check and see...if not I have the drawing for a romanian receiver...but im still not sure..if the holes are far enoug away from each other that I could drill new ones without cutting into the original holes....thanks tho __________________ Two weapons that was designed by the same man still in use by the us military 100 years later...1911 and m2...is there anything that comes close.....lol annd maybe perhaps a sig sauer p226 tac ops edition..

April 20, 2011, 05:47 PM	#2
Dfariswheel Senior Member Join Date: May 4, 2001 Posts: 7,478	As long as you have an unfinished NoDak Spud receiver, most any AK parts will fit. Where you might have trouble is with a receiver that's already had the trunnion holes drilled and won't line up with whatever kit you have.

April 26, 2011, 10:27 PM	#4
5.45 Shooter Member Join Date: April 26, 2011 Posts: 37	As long as your receiver is not the Hungarian AMD 65 it will fit. If it is the AMD 65 the only diferance is the rear trunnion.