The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools Search this Thread
Old November 2, 1998, 02:14 PM   #1
Steve Koski
Member
 
Join Date: October 19, 1998
Location: Spanish Fork UT, USA
Posts: 86
After doing some polishing on some Ruger 10-22 trigger group parts I'm wondering what action to take. I've removed the black coating from the sides of some of the parts. Should I attempt to re-finish these somehow? If so, what do you recommend? If not should I just wipe them down with an oily rag and install them, or should I just put them in dry?
Steve Koski is offline  
Old November 2, 1998, 04:44 PM   #2
Kodiac
Senior Member
 
Join Date: August 16, 1999
Posts: 1,173
There are several different things you can do here. Refinishing is an option, but not the most economical one...
Try one of the many solutions aout there that will put a barrier/lubricant over the parts but is resistant to collecting debris/dirt. Look for one that leaves a dry film. My local shop has a new one that leaves a "Molly" coating. That would be good, but I havn't tried it yet.

Kodiac is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:14 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.03805 seconds with 8 queries