The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Tactics and Training

Reply
 
Thread Tools Search this Thread
Old November 20, 2014, 12:41 PM   #51
brokenolmarine
Junior Member
 
Join Date: November 17, 2014
Posts: 6
I taught LE firearms for years, coached in the Corps, and taught private classes. Two suggestions.

1. Someone else hit on what I though of first.
You may not be flinching, there are two things you may be doing that can cause those low shots.

a. Milking the grip: squeezing the trigger with your whole hand rather than the trigger finger alone.... aka milking.
When you tighten the bottom three fingers at the last instant as the trigger breaks, it pulls the muzzle down and the shot low. YOU control the trigger with the trigger finger, you grip the gun with your hand. Concentrate on TRIGGER control.

b. Looking Over the sights at the last second to see the impact of the shot.
When you do this, you drop the sight to see the target. I laugh and tell my students that the HOLES don't leave or hide, they'll still be there after follow thru. Make an effort to watch the front sight all the way thru the shot. Think FRONT SIGHT and focus solely on the sight, see the sight clearly as you apply trigger pressure until the shot breaks as a surprise. The last thing you saw when the shot broke should have been the CLEAR TIP OF THE FRONT SIGHT.

A drill to help you with trigger control is very simple and very cheap. All you need is a spent casing from your Glock 19... that's the gun you mentioned, right? (regardless of the gun used, I normally use a .38 casing)

UNLOAD and physically confirm a safe weapon!
Rack the slide to cock the striker
Balance the empty casing on the end of the slide just in front of the front sight.
You won't be able to see the front sight.... no problem
(You may find the drill easier if you paint a vertical line on the casing with a Sharpie)
Extend the pistol toward your target and sight as if the center of the casing was your front sight.
Squeeze the trigger smoothly concentrating on the sights, using the casing as your front sight ... until the trigger breaks.

If your trigger pull is smooth and undisturbed, the case will NOT fall off the slide. In fact, it won't move. It will flinch slightly when the striker breaks. Nothing else.

Tilt the glock, catch the casing and repeat the drill. Recock the striker by drawing the slide to the rear to cock the trigger / striker.
brokenolmarine is offline  
Old November 20, 2014, 05:10 PM   #52
davem
Junior member
 
Join Date: October 4, 2004
Posts: 458
Yeah, there's a lot of different drills, I heard some guys used to take a match book- back when they had them, and practice bending over the lid.
I'm not sure but usually if you are pulling the shots, they'll all group off to one side. I had that trouble for a while- I was curling my finger too far around the trigger and getting a little sideways movement. If I shot on sandbags with two hands- right on so that's how I figured my one handed shooting was my fault and not the gun. It's more of an issue shooting double action with a longer trigger pull.
davem is offline  
Old November 20, 2014, 05:21 PM   #53
riflemen
Junior member
 
Join Date: November 18, 2014
Posts: 259
When my son started shooting he had a "flinch" and I taught him the same way my father taught me...

I told him to put the bottom of his tongue on the top gums behind his teeth and as he squeezed the trigger, flick his tongue down to make that popping noise we make when we are kids... It works, for some reason your brain wont let you flinch, its doing to many things at once... My father was taught that by his brother, my uncle {vietnam sniper}. It works, I have showed a few guys over the years how to do it, then after a while you dont need to do it, and can shoot good...

Another thing that helped a buddy of mine was shooting glasses, he was flinching from the flash and the glasses stopped it...
riflemen is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:29 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2018 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.04684 seconds with 8 queries