September 4, 2009, 06:08 PM | #1 |
Senior Member
Join Date: August 25, 2009
Location: SW Florida
Posts: 103
|
Lyman T-Mag II Problem
I just got a new Lyman T-Mag II press and wanted to ask if there is some trick to getting the handle screwed into the Toggle?. It almost seems as if the handle is to big for the hole in the toggle,the threads look good so i'm confused as to why this is. If anyone has dealt with this before i'd appreciate any advice.
|
September 4, 2009, 07:02 PM | #2 |
Senior Member
Join Date: March 28, 2006
Location: Maine
Posts: 846
|
T-Mag
Mine fit fine. Just be sure it is aligned properly, screw it in and lock it with the nut
|
September 4, 2009, 07:29 PM | #3 |
Member
Join Date: July 21, 2009
Location: Southeastern Ohio
Posts: 67
|
You got the angles working against you. It screws in there. You just got to get everything aligned with each other. Hang in there, you'll get it.
|
September 4, 2009, 09:14 PM | #4 |
Senior Member
Join Date: August 1, 2007
Location: Tabor City , NC.
Posts: 1,969
|
Threads
line it up then turn counter clockwise till ya feel a click in the threads then start turnin clockwise.
if threads are buggered i`d suggest chasing em , but ya mite get by starting em from the back side . I love fine threads !!!
__________________
GP100man Last edited by GP100man; September 4, 2009 at 09:14 PM. Reason: addition & spelun |
September 5, 2009, 02:07 PM | #5 |
Senior Member
Join Date: August 25, 2009
Location: SW Florida
Posts: 103
|
Thank's,it did finally screw in after a bit of cussing at it,lol. I was just worried because i had another one that was defective and this was the replacement so i was hoping that i wasn't gonna have to send this one back also. Thank's again.
|
|
|